IronPort Systems 4108GL Manual de usuario descargar pdf (Pagina 299)

100

101

13-41

HP Procurve Stack Management

HP Procurve Stack

Management

Syntax: stack member <switch-number>

mac-address <mac-addr>

[password<password-str>]

In the destination Commander, use show stack all to find the MAC address of

the Member you want to pull into the destination stack. For example, suppose

you created a new Commander with a stack name of “Cold_Waters” and you

wanted to move a switch named “Bering Sea” into the new stack:

Figure 13-32. Example of Stack Listing with Two Stacks in the Subnet

You would then execute the following command to pull the desired switch

into the new stack:

HP4108(config)# stack member 1 mac-address 0060b0-df1a00

Where

1 is an unused switch number (SN).

Since a password is not set on the Candidate, a password is not needed in this

example.

You could then use

show stack all again to verify that the move took place.

Using a Member CLI To “Push” the Member into Another Stack. You

can use the Member’s CLI to “push” a Switch 4108GL stack Member into a

destination stack if you know the MAC address of the destination Commander.

Syntax: stack join <mac-addr>

where: <mac-addr> is the MAC address of the Commander for the desti-

nation stack.

Converting a Commander to a Member of Another Stack. Removing

the Commander from a stack eliminates the stack and returns its Members to

the Candidate pool with

Auto Join disabled.

Move this switch into the “Cold Waters” stack.

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 482 483

Comentarios a estos manuales

Sin comentarios

IronPort Systems 4108GL Manual de usuario Pagina 299

Comentarios a estos manuales